I have a 71 monte carlo and i wanted to know if any of you have done floor pans? I just seen today that i have rot in the front drivers side floor pan.

how much of the pan are you looking to replace? we did full pans in a El Camino main thing is to drill out the spot welds on the floor braces.

Well all i seen sofar was the drive side front floor,But i may do all of them front to back.

Yesterday I finally received my front 1/4 floor pan from Lutty's. It's just the drivers floor section.....$55. I'm actually only going to use a 12"X8" piece. My buddy is the welder so he gets the car tomorrow. Pull your seats and all the carpet to make sure what you need. I had a bad spot under the back seat which was already fixed

Thanks Murphy for the picture,More picture of the job is welcome.

Here's another of the complete floor, it's excellant (I think) for 40+ yrs old.
Once I get it back from welding shop, I'm covering everything in HushMat then new carpet.

NIce bro

Saw your post on face book Jim and thought damn that name looks farmiler. duh

Those floors dont look to bad other than thay one spot, once you get that fixed and that rust cleaned up your good to go.

Hey bro.. Yeah them pictures of the floors are not my pictures,But i will be getting out there today to look in to it more and take pictures,